Introduction to the structural characteristics of the automatic sleeve labeling machine

Sleeve labeling machine has been fully affirmed by the majority of customers for its excellent high-speed stable performance, unique smart design, and human-machine coordinated safety mode. Application fields: food, beverage And the pharmaceutical industry, condiments, juices, injection needles, milk, refined oils, etc. The following editor briefly introduces the structural characteristics of the automatic sleeve labeling machine, as shown below:

1. Shrinking furnace: Use electric heat or steam heating to shrink the label of the bottle into the bottle, and then stick it to the bottle evenly.

2. According to the electric eye of the bottle: monitor the bottle to the appropriate position, output the signal, so that the host can automatically insert the label.

3. Bottle group: Synchronous transmission on both sides, height and bottle position are only adjusted by one hand wheel, so the bottle will not shake during transportation and control the height of the label.

4. Transmission group: The double transmission feeding mechanism is adopted, which is part of the fixed central column. Whether the bottle gets bigger or smaller, just turn the handwheel to change the size you want. Transmission functions are accomplished through gear sets.

5. Dispensing Screws: Separate the bottles equidistantly and enter the bottle group.

6. Brush Set: Use a strap or rubber band to insert the bottle label into the bottle.

7. Whole machine: The whole machine adopts a stainless steel body to support the host and a fixed conveyor belt.

8. Center post: Sleeve the label film material into the opening so that the film material can be transported and cut.

9. Cutter group: It adopts eccentric linkage mechanism and is driven by stepping motor. It has no rotating action without bottle sensing, which increases longevity and safety. At the same time, it uses a common cutting blade. Replacement is easy and economical.

10. Human-machine interface: It is the control of the machine. Each operation display page is divided into main table, manual, automatic, setting, monitoring, etc., and uses several auxiliary knobs to operate the control sleeve label operation.

11. Brush group: Using the synchronous adjustment mechanism, adjust the two groups of transfer wheels to the lower part of the center column, and make the rollers touch slightly. After the label has passed, the label will be put into the bottle at a higher speed.

12. Electric eye frame group: The optical fiber electric eye is used to transmit the signal, the control system is used for transportation of fixed size, and the position of the electric eye can be adjusted.

13. Preheat shrink: used to place the label before entering the shrink oven to prevent the label from moving.

14. Tri-color warning light: During normal operation, it is a green warning light. When ready, it will flash. When the host is not healthy, it will flash red.

15. Feeding group: It consists of a feeding box and a feeding motor, which control the feeding force of the label to transfer the label film.

16. Double rack group: save oiling time, unloading is provided by a group of conveying roller deceleration motor.

17. Conveyor belt: use the frequency converter to adjust the speed of the conveyor belt, which is suitable for speed matching of various production capacities. The machine is also synchronously controlled by three parts of bottle screw group, bottle group and conveyor belt, realizing single-knob speed adjustment.